Newair 281

[Erikcooper]

I've posted on a few old topics about setting up this wineador and read about removing the clips that hold on the metal shelves. I just tried to pull them out and only succeeded in breaking one. Any tips on and easy way to get them out?


Sent from my iPhone using Tapatalk

 

[Npeters7]

That's what I did.. Just break them off.. Don't know of an easier way.

 

[problemsolverjc]

Break em off....

Sent from my ONE A2005 using Tapatalk

 

[Lapithicus]

I took the blade off a hacksaw and just scored the inside corner edge. Just one swipe scores it so you can then bend it down and break it off cleanly. Did them all in a couple of minutes.

 

[Mossome]

I did about the same thing except I used a utility knife.

 

[Erikcooper]

This is what stayed when it broke. With this there you can't slide in drawers


Sent from my iPhone using Tapatalk

 

[Erikcooper]

In the second pic you can see the full clip below. The left and right sides broke off without the middle part coming with them


Sent from my iPhone using Tapatalk

 

[knw247]

That's how mine look

 

[Erikcooper]

So your shelves work fine even with that piece being left in there?


Sent from my iPhone using Tapatalk

 

[stin187]

I used pliers and just snapped them. Whatever stayed in the track stayed. The fit on both sets of drawers I had were no where near tight enough that the little bit left over mattered.

 

[KFBR392]

that's how mine are too. I just pulled them off with pliers. Don't worry about the little bet left over. Drawers will fit fine and you'll never see or noticed the leftovers

 

[Tennessee Dave]

Score them with a hack saw blade and just pop them off. Works like a charm.

 

[TravisNTexas]

I'm going to have to deal with this in a couple of weeks. Has anybody tried a small sharp chisel with the flat side against the main body?

 

[RacFocus]

All you need is a pair of pliers to bend off the part that sticks upward. Mine fit without breaking out all the other plastic.


Sent from my iPad using Tapatalk