It was over a year ago and someone from here gave me a very detailed drawing on wiring, it may have been you, but I followed it and my settings were 65 degrees and I am not sure about the time out setting. I know that my fridge would not get any warmer than the lowest setting, according to my thermometer that I had in the fridge, If I remember right, it stayed around 40-50 degrees, too cold. I have 2 fridges now and they are running as set from factory. so far so good. but it often made me wonder about trying again...Given that the OP's question was answered... 1. how did you wire the ETC's temp sensor, and 2. what settings did you have on it? (Temp range, time delay, etc)Makes total sense, but mine wouldn't do that, it just kept running nonstop after it came back on. It would run it till it was at the lowest setting and it just kept running. I took it out and left the fridge run as it was made at the factory.
Ps, I was just posting my experience, I didn't mean to high jack the original post and he needs his question answered before me....